1. Manuals
  2. Laundry Appliance Support
  3. Equator Support
  4. Washer/Dryer Support
Support User Manuals
Question About Equator Washer/Dryer 3612 cee
door handle spring...

i have the same problem!!! i think i'm close to fixing it though. Did you figure it out? i'd love to hear from you if you did. good luck!! brandi

Asked by brandi on 04/23/2009 1  Answer

ManualsOnline posted an answer 15 years, 8 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Anthony posted an answer 15 years, 7 months ago

0 On my machine the door handle is connected to a timer for safety reasons. Wait about 30 seconds then try the door. As far as water in the tub...On the front of your machine (or possibly the back) there is a small spring loaded flap. Open it and you will find a round piece of plastic being held on by a singular screw. There might be two larger screws just outside of this but leave these alone since these hold the whole assembly together. Remove this small singular screw (DON"T LOSE THIS SCREW!) and twist to the left and pull out. Get a small bucket or a good absorbant towel to catch the small amount of water. When you pull this out you will find a small tray. This is the lint trap for the wash water. Clean out all the gunk and reinstall. Carefull not to over-tighten the screw or you will strip the threads. My problem was a coin got stuck in it and it wouldn't let the water go to the pump to be pumped out. The machine has a safety switch so if it can't pump all the water out it automatically shuts down(which is what mine did). Once I cleaned the tray out all the problems went away including the water in the tub and the over-filling problem. Hope this helps you.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual