Fabric softener doesn't dispense. Load cycle completes but softener still in dispenser at end of cycle. Has happened before with soap but that usually empties.

Asked by Marsha on 07/02/2014 2  Answers

ManualsOnline posted an answer 10 years, 4 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
0 Good Afternoon M.dockter, I understand the fabric softener is not dispensing in your Electrolux washer, model# EIFLW55HIW. I also see that it will run through the whole cycle and the softener is left in the dispenser. I suggest cleaning the dispenser drawer are by: 1) Remove the drawer by pulling the drawer out until it stops. 2) Reach back into the left rear corner of the drawer cavity and press down firmly on the lock tab. Pull out the drawer. 3) Remove the insert from the prewash, bleach, and fabric softener compartments. 4) Rinse the drawer and inserts with hot tap water to remove traces of accumulated powders and liquids. Large amounts of fabric softener residue may indicate improper dilution or more frequent cleaning is required. 5) To clean the drawer opening, use a small brush to clean the recess. Remove all residue from the upper and lower parts of the recess. 6) Replace the insert by pressing it in place until you hear a slight click. Return the dispenser drawer. I also suggest resetting your appliance, by either unplugging it or shutting the power off at your home’s circuit breaker, for 3-5 minutes. Restore power and start any cycle. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your appliances status has changed successfully. Hope this is helpful. -Best Regards-
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.