the drive belt has come off, how do I reconnect it as you cant take the back of the machine?

Asked by Janet on 02/07/2014 1  Answer

ManualsOnline posted an answer 10 years, 2 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
5 1 Unplug from the mains and remove the hose. Remove the top panel (3 screws at the back) then lay the machine on it's back 2 Remove the small panel at the front of the machine (under the door) push the 3 plastic lugs in to release 3 Undo the screws and remove the metal panel underneath 4 The whole front panel of the machine can now be pulled out from the bottom to give enough access to be able to get the new belt over the drum 5 At this stage , check the 2 jockey wheel tensioners to ensure that they are in good condition and run freelly, as they are a weak point of the machine, one of mine was broken 6 Open the door, then feed the belt from the top, (line up with the lines on the drum left by old belt) an extra pair of hands is handy here to hold the belt in place around the drum.....then with strong hands and a lot of pressure, pull the belt over the motor spindle. ( it will help here if you undo the motor mounting screws to lessen the gap as it makes it easier to get the belt on, but do not take the screws right out) Leave the jockey wheels behind the belt at this stage. 7 Pull out one of the wheel tensioners and locate onto the belt 8 Do the same with the other ( quite strong hands needed again) 9 Check that the belt is correctly aligned around the drum, re-tighten the motor screws, then replace all screws and panels in reverse order of removal. 10 Replace hose and plug in and start up and sit down and relax in the knowlege that you have just saved yourself a lot of money.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.