Filter
Top Products
Positioning
The appliance may be placed on any type of flat floor.
It must be perfectly level (use a spirit level if neces-
sary). Adjust the feet to compensate for any uneven-
ness in the floor.
To ensure correct operation, the surrounding area
must be kept clean, free of dust and fluff.
Air must be able to circulate freely all round the appli-
ance. Do not obstruct the front ventilation grille or the
air intake grilles in the back of the machine.
Do not remove the feet.
Do not reduce the clearance between the appliance
and the floor by placing it on deep pile carpet or rugs,
as this could lead to a build-up of heat which would
adversely affect operation of the machine.
Important:
The hot air emitted by the tumble dryer can reach
temperatures of up to 60°C. The appliance must
therefore not be installed on floors which are not resis-
tant to high temperatures.
The ambient temperature must not exceed 35°C, even
when the appliance is working. If it does, open the
door or window.
Door Reversal Instructions
The appliance is supplied with the door opening from
right to left. If you wish to change the opening direc-
tion, proceed as follows (see picture A):
1. Unhook door stopper «A» from its seat «a» and
loosen from hole «b» by a 90° rotation.
2. Remove the plastic plug from hole «c» by a 90°
rotation and re-fix in hole «b».
3. Unscrew hinge «B» (loosen the 2 screws, holding
the door securely) and lower the door from the top
pivot.
4. Re-insert pin «F» from the door above and below
on opposite sides respectively.
5. Loosen door catch «C» by pressing both lugs
together (see small illustration).
6. Loosen opposite plastic part «D» as in step 5 (you
may need to use a screwdriver to assist in both steps
5 and 6 ).
7. Interchange and insert parts «C» and «D».
8. Remove screws «E» and refit on the opposite side.
Fix hinge «B» on the right handside.
Do not fully tighten the screws.
D
b
c
E
B
A
d
F
1
1
2
C
P0866
a
C
INSTALLATION
A
5