Filter
Top Products
8
• The washing machine has completed the
programme: this is indicated by a flashing zero.
Important!
The first time you use the washing machine, when
you switch it on, it may display a flashing zero. This is
due to the fact that the washing machine has performed
a washing cycle during the manufacturer’s inspection
tests, and this cycle has not been erased after its
completion.
• An incorrect option selection has been made: this is
indicated by the message Err when a function
incompatible with the current programme is selected.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 22-23).
8
“Drying Time” button
By depressing this button you can select a timed
programme for cotton or synthetics, the relevant light
illuminates.
E20
0
For Cottons and Synthetics you can select a drying
time from 10 minutes to 130 minutes (
2.10).
Every time you press the button the time increases by
5 mins.
9 “Start/Pause” button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the machine. The
light above the button will stop flashing and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
10 Programme phase indicator
lights
When you select a programme, all the pilot lights are
off.
After you have started the programme, the “Function”
light illuminates.
At the end of the washing or drying programme, the
“Function” light goes off and the “End cycle” light
illuminates.
Function
Drying
End cycle
Drying
Time
Time
60
132981630revised.23.01.07.qxd 23/01/2007 9.28 Pagina 8