Filter
Top Products
11
7. Start the programme
Press the “Start/Pause” button. The relevant light will
stop flashing and remain lit. The “Function” pilot light
illuminates.
8. How to change an option or a
programme during its cycle
If the programme has already started, before you make
any change, you must pause the washing machine by
pressing the Start/Pause button.
It is possible to change any option before the
programme carries it out.
Changing a running programme is possible only by
cancelling it and selecting a new programme. Turn the
programme selector dial to “O” Off position and then to
the new programme position. The washing water
remains in the tub. Start the new programme by
depressing the Start/Pause button.
Note: To drain the water before starting the new cycle
you have to cancel the programme and select the Drain
programme.
9. How to cancel a programme
during its cycle
Turn the selector dial to “O” Off position to cancel a
programme which is running. Now you can select a new
programme.
10. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
Start/
Pause
If these requirements are met, when you pause the
washing machine, the door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by turning the selector dial on Off position.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the washing machine!
After closing the door, select the programme again and
depress the Start/Pause button.
11. End of programme
At the end of the programme, the washer-dryer stops
automatically.
The light of the “Start/Pause” button goes off, the pilot
light “Function” goes off and the phase indicator light
“End cycle” illuminates.The display will show a
flashing zero.
If you had selected the “Rinse Hold” option, the
corresponding lights will be on, the display will show a
flashing zero but the door will be locked to indicate that
the water must be drained.
To complete the cycle, there are 2 possibilities :
• turn the selector dial to the “O” Off position, select
programme “Drain” and then depress the
Start/Pause button: the water is emptied out without
spinning.
or
• turn the selector dial to the “O” Off position and
then select programme “Spin”. Select the spin speed
by means of the relevant button and then depress the
Start/Pause button. The water is emptied out and
the laundry is spun at the selected spin speed.
When the programme has been completed, the phase
indicator light “End cycle” illuminates.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing machine.
132981630revised.23.01.07.qxd 23/01/2007 9.28 Pagina 11