Whirlpool WTW5500 Washer User Manual


  Open as PDF
of 4
 
DELIVERY & INSTALLATION
This Delivery & Installation Pointer Applies To The Following Brands:
Whirlpool
®
KitchenAid
®
Jenn-Air
®
Admiral
®
Maytag
®
Magic Chef
®
Amana
®
Roper
®
®Registered trademark/™ Trademarks of Whirlpool, U.S.A., KitchenAid, U.S.A., Jenn-Air, U.S.A., or Maytag Corporation or its related companies.
© 2010 All rights reserved.
POINTER
Top Load Washers with Dispenser Drawer
DP8178819
July 2010
Washer not agitating, spinning, or not pumping water out when testing the washer after
installation.
Check electrical connections at the motor, capacitor and pump. Push connector all the way
into the housing. This can be done at the point of installation when the washer is tilted back to
install the bottom insulation pad to resolve this issue.
ISSUE:
RESOLUTION:
CORRECTIVE ACTION:
1. Follow all installation instructions step by step, heeding the Safety warnings throughout.
2. Note step1 on next page for sound shield insulation.
3. PRIOR to continuing with step 2, check electrical connections at the motor, capacitor and
pump. Push connector all the way into the housing. (Figure 1, next page).
4. Continue with step 2 in sound shield insulation, as shown on next page.
5. If Electrical connections are not checked, as noted above in Corrective Action number 3,
and washer is not agitating, spinning, or not pumping water out when testing the washer
after installation, please uninstall and check connections as noted above.
Washer not agitating, spinning, or not pumping water out
WTW5500 WTW5700 MVWX500 MVWX700
Models:
WARNING
Electrical Shock
Hazard
Disconnect power before servicing.
Failure to do so can result in death
or electrical shock.
Replace all parts and panels before
operating.
next