Filter
Top Products
7
6. Set the TEMPERATURE selector to the correct setting for the
type of fabric and soils being washed. Use the warmest water
safe for fabric. Follow garment label instructions.
■ Your washer uses the ACCUWASH
™
automatic
temperature control. The ACCUWASH feature maintains a
uniform water temperature by regulating incoming hot
and cold water. This helps eliminate undissolved
detergent and ensures consistent cleaning results. The
cold wash is regulated at approximately 75ºF (24ºC). The
warm wash is maintained at approximately 100ºF (38ºC).
NOTE: Make sure that both hot and cold water faucets
are turned on or the ACCUWASH feature will not work
properly.
NOTE: In wash water temperatures colder than 70ºF
(21ºC), detergents do not dissolve well. Soils can be difficult
to remove. Some fabrics can retain wear wrinkles and have
increased pilling (the formation of small lint-like balls on the
surface of garments).
7. (OPTIONAL STEP) For an additional rinse and spin at the end
of a wash cycle, set the EXTRA RINSE selector to ON.
8. (OPTIONAL STEP) Set the CYCLE SIGNAL selector to ON if
you want your washer to sound a signal when the wash cycle
is finished. The signal is helpful when you are washing items
that should be removed from the washer as soon as the cycle
ends.
9. Push in the Cycle Control knob and turn it clockwise to the
wash cycle you want. Reduce the wash time when using a
small load size setting. See “Selecting a Cycle and Time.”
Pull out the Cycle Control knob to start the washer.
To stop or restart your washer
■ To stop the washer at any time, push in the Cycle Control
knob.
■ To restart the washer, close the lid (if open) and pull out
the Cycle Control knob.
Selecting a Cycle and Time
This section describes the available wash cycles and will help
you make the best cycle selections for your wash loads. Each
cycle is designed for different types of fabric and soil levels.
■ The washer pauses briefly throughout each cycle. These
pauses are normal. Refer to “Normal Washer Sounds” to
learn more about the sounds you may hear during a wash
cycle.
■ Refer to “Understanding Washer Cycles” to learn what
happens during a wash cycle.
Normal cycle
This cycle features high-speed agitation for cleaning cottons and
linens, and high spin speed to shorten drying time. Select up to
15 minutes of wash time, depending on whether your load is
lightly, moderately or heavily soiled. For lightly soiled cotton and
linen fabrics, use the shortest time setting.
Casual/Permanent Press cycle
This cycle starts with high-speed agitation and then steps to low-
speed agitation for cleaning permanent press blends and
synthetic fabrics. To minimize wrinkling, this cycle features a
cool-down rinse and a low-speed final spin. Use this cycle to
clean lightly to moderately soiled loads.
Delicates cycle
This cycle features low-speed agitation for gentle soil removal
from delicate items and washable knits. Low spin speeds
minimize wrinkling. Use this cycle to clean lightly to moderately
soiled loads.
Hand Washables cycle
This cycle features a series of brief, low speed agitations and
short soaks to gently clean special-care items. Low spin speeds
minimize wrinkling. Wash small loads. If items appear to be
floating (due to trapped air), stop the washer by pushing in the
Cycle Control knob. Push items down into the washer. Pull out
the Cycle Control knob to restart the washer.
Rinse and Spin
When using extra detergent for heavily soiled clothes, or washing
special-care items, you may find an extra rinse and spin is
needed.
1. Push in the Cycle Control knob and turn it clockwise to any of
the Rinse settings.
2. Pull out the Cycle Control knob. The washer fills to the
selected load size, agitates, drains, and spins.
NOTE: Your washer has an EXTRA RINSE selector that allows
you to add an extra rinse automatically to any wash cycle. See
“Starting Your Washer.”
Drain and Spin
A drain and spin may help shorten drying times for some heavy
fabrics or special-care items by removing excess water.
1. Push in the Cycle Control knob and turn it clockwise to any of
the Spin settings.
2. Pull out the Cycle Control knob. The washer drains, then
spins.
Water Temp Use For
Hot
111°F (44°C)
or above
Whites and pastels
Heavy and greasy soils
Warm
90°-110°F
(32°-43°C)
Bright colors
Moderate to light soils
Cold
70°-90°F
(21°-32°C)
Colors that bleed or fade
Light soils