5
■ Hot and cold water faucets located within 4 ft (1.2 m) of
the hot and cold water fill valves, and water pr
essure of
20-100 psi (137.9-689.6 kPa).
■ A level floor with a maximum slope of 1" (25 mm) under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
■ A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 lbs (180 kg).
Do not operate your washer in t
emperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures. See “Washer Care” in the Washer User
Instructions for information on winterizing.
Installation clearances
■ The location must be large enough to allow the washer door
to be fully opened.
■ Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90°,
and it is not reversible.
■ Additional clearances might be required for wall, door,
and floor moldings.
■ Additional spacing of 1" (25 mm) on all sides of the washer
is recommended to reduce noise transfer.
■ Companion appliance spacing should also be considered.
Washer Dimensions
5
0
1
/
4
"
(1276 mm)
27
"
(686 mm)
36
"
(914 mm)
30
1
/
2
"
(775 mm)
Recommended installation spacing for custom undercounter
installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
27
"
(686 mm)
1
"
(25 mm)
1
"
(25 mm)
2
" (50 mm)
36
" min.
(914 mm)
Recommended installation spacing for recessed or closet
installation, with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
3
"
(76 mm)
48
"
(1220 mm)
3
"
(76 mm)
48 in.
2
(310 cm
2
)
24 in.
2
(155 cm
2
)
1
"
(25 mm)
4
"
(102 mm)
30
1
/
2
"
(775 mm)
A
B
A.Side view - closet or confined area
B.Closet door with vents
Recessed or clo
set installation - Washer on pedestal
38
" min.
(965 mm)
1
"
(25 mm)
27
"
(686 mm)
AB
1
"
(25 mm)
1
"
(25 mm)
4
"
(102 mm)
30
1
/2
"
(775 mm)
A.Recessed area
B.Side view - closet or confined area