Filter
Top Products
14
Pausing or Restarting
1. To pause the washer at any time, press START/PAUSE.
2. To continue the cycle, press and hold START/PAUSE (for
approximately 1 second).
Changing Cycles and Options
Not all Options are available with all Cycles.
Cycles and Options can be changed anytime before START is
pressed.
To cancel a cycle
1. Press POWER.
2. The washer powers down, the door unlocks, and clothes can
be removed.
NOTE: If
the water level or the temperature is too high, the washer
will drain automatically before the door unlocks.
To change Options after the cycle has started
1. Press START/PAUSE once.
2. Press the desired OPTIONS. If the option is not available, the
machine will beep.
3. Pr
ess and hold START/PAUSE (for approximately 1 second) to
continue the cycle.
NOTE: Pr
ess OPTIONS button until TumbleFresh light glows to
add periodic tumbling after the wash cycle is finished. The light
will glow when this option is selected and will remain flashing for
up to 6 hours or until the washer is stopped by either pressing
POWER or opening the door.
To drain the washer manually
1. Press START/PAUSE.
2. Pr
ess RINSE/DRAIN & SPIN.
3. Deselect EXTRA RINSE option.
4. Press and hold START/PAUSE (for approximately 1 second) to
begin the drain.
5. Wh
en the spin is complete, the door unlocks. Items can be
removed from the washer.
Status Lights
These lights show which portion of the cycle the washer is
operating. They also indicate when you can add an additional item
to the wash cycle and when the controls are locked.
Adding items
You can add items to the washer after the wash cycle has started,
if the Add a Garment status light is illuminated. All cycles have this
feature except Rinse/Drain & Spin, and Clean Washer with
AFFRESH™ cycle.
To add items
1. Pr
ess START/PAUSE. The washer door unlocks, and items
can be added.
2. T
o continue the cycle, close the door and press and hold
START/PAUSE (for approximately 1 second).
NOTE: T
o add garments after the Add a Garment period is over,
the wash cycle needs to be canceled, the items added, and a new
wash cycle started.
Done
The Done light comes on after the cycle is complete. The light will
stay on until door is opened.
Locking controls
The Control Lock avoids unintended use of the washer. You can
also use the control lock feature to avoid unintended cycle or
option changes during a cycle. When CONTROL LOCK is lit, all
buttons are disabled except for START/PAUSE, POWER, and
SIGNAL. You can lock the controls while the washer is operating.
To lock the controls
Press and hold SIGNAL for 3 seconds.
The CONTROL LOCK status light illuminates.
To unlock the controls
Press and hold SIGNAL for 3 seconds until the CONTROL LOCK
St
atus light turns off.
Estimated Time Remaining
The cycle times vary automatically based on your water pressure,
water temperature, detergent, and clothes load. The cycle time
will be extended if oversudsing occurs or the load is unbalanced.
The options you select will also change the cycle times that are
shown in the Factory Default Cycle Settings table. The Estimated
Time Remaining can change up to 30 minutes under extreme
con
ditions.
Door Locked
When the status light illuminates, the door is locked. The door is
locked and unlocked automatically, depending on the stage of the
wash cycle.
Cycles
Wash Cycles
Choose Wash Cycles by rotating the Cycle selector knob to the
desired cycle. The indicator light for the cycle selected will
illuminate. Each cycle is designed for different types of fabric and
soil levels.
■ Each cycle has a preset cycle time. TEMP and SPIN SPEED
may have preset Options. The preset settings provide the
recommended fabric care for the selected cycle.