Filter
Top Products
11
8. Select CYCLE
The display will show the default settings for the selected
cycle. If desired, press the button beneath each setting to
adjust the Temperature, Soil Level, Spin Speed, and Cycle
Signal. Adjusting the Soil Level will change the Estimated Time
Remaining. Overloading, unbalanced loads, or excessive suds
may also cause the washer to increase the cycle time.
NOTE: Not all settings are available on all cycles. See “Cycle
Guide” for available settings.
Turn cycle knob to select your wash cycle. See “Cycle Guide”
for details on cycle features. Not all options and settings are
available on all cycles.
9. Adjust settings, if desired
10. Select any additional options
12. Press and hold START/PAUSE
to begin wash cycle
To add additional options to the cycle, such as the EcoBoost
™
option, Deep Clean/Deep Clean with Steam (on some models),
or Presoak, press the button for the desired options to add
them to the selected cycle.
NOTE: Not all options are available with all cycles. See “Cycle
Guide” for available options.
Press and hold the START/PAUSE button to start the wash
cycle. To pause a cycle in progress, press the START/PAUSE
button once, then press and hold again to continue the cycle.
To cancel a cycle, press the POWER button.
Once you press and hold START/PAUSE, you will hear the
door lock, unlock, and lock again. The washer door will remain
locked during the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2 missed garments,
you may do so while the “Add a Garment” light is lit.
Press START/PAUSE once; the door will unlock
once the washer movement has stopped.
This may take several minutes. Then close
door and press START/PAUSE again to restart
the cycle.
11. Setting a delayed start
If you do not want to begin a cycle immediately, you may
choose the DELAY START option. This will delay the start
of the wash cycle by up to 16 hours on models with Steam,
and 12 hours on non-Steam models.
To set a delayed Start:
1. Press DELAY START s and t buttons to set the desired
delay time.
2. Press START/PAUSE to set the delay. The delay countdown
has started when the START/PAUSE light stops blinking.
C
W
W
S
G
FanFresh
Delay Start
Door LockedSensing
Estimated Time Remaining
Delay Set
Steam model shown
Steam model shown
Steam model shown