Filter
Top Products
4-26
18. Using the procedure in step 13, remove
the two front shock absorbers from the
tub.
19. Lift the tub and basket assembly and un-
hook the two suspension springs, then
remove the assembly from the washer,
and place it front-down on a padded sur-
face so that the back pulley faces up.
NOTE: The suspension springs are in-
stalled in the front slots of the cabinet, as
well as in the tub. Do not use the back
slots; they are used with other models.
20. Remove the 15/16 inch hex-washer nut
from the drive pulley and remove the pul-
ley from the basket shaft.
Front Slot
Front Slot
Front Holes
21. Mark the edges of the 23 tub clamps with
a pencil so that you can reinstall the clamps
in the same locations later.
22. Use a screwdriver blade, and pry off the 23
tub clamps.
Drive Pulley Nut
Drive Pulley
Pencil Marks
Tub Clamp
Pry Clamp Out
Screwdriver
Tub Clamp
Continued on the next page.