Filter
Top Products
4-23
REMOVING THE TUB AND BASKET ASSEMBLY
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the detergent dispenser assem-
bly (see page 4-8 for the procedure).
4. Remove the heating element & tempera-
ture sensor (see page 4-16 for the proce-
dures).
5. Remove the drain pump assembly (see
page 4-18 for the procedure).
6. Remove the airtrap from the washer (see
page 4-19 for the procedure).
7. Remove the drive motor and belt (see
page 4-22 for the procedure).
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
9. Loosen the clamp and pull the end of the
air inlet hose from the tub.
Top Brace
8. Remove the T-20 hex-head torx screws
from the top (and bottom, if not already
done in step 7) braces and remove both
braces from the rear of the washer.
Air Inlet Hose
Excessive Weight Hazard
Use two or more people to move
install washer.
Failure to do so can result in back or
other injury.