Filter
Top Products
4-12
REMOVING THE INTERFERENCE FILTER
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the console
(see page 4-2 for the procedures).
Interference Filter
4. Disconnect the three connectors from the
interference filter terminals. NOTE: The
green 2-wire connector has a locking arm
at the bottom that you must press to re-
lease the connector.
5. Remove the two T-20 hex-head torx screws
from the interference filter and remove the
filter from the washer.
T-20 Torx Screws
Black White
Wires
2-Wire
Connector