Filter
Top Products
4-3
e) Press the locking tab on the right rear
side of the console, and pull out on the
console to disengage the tab from its
slot.
d) Remove the T-20 torx screw from the
recessed hole of the console.
f) Pull out at the bottom of the console
and lift it to unhook the top edge from
the cabinet, and remove the console.
6. To remove the touchpad / LED assem-
bly:
a) Use a small screwdriver and unsnap
the three top locking tabs from the
touchpad/LED assembly.
b) Starting from the right, unsnap the four
lower locking tabs from the touchpad/
LED assembly, and lift the assembly
from the console. NOTE: If the push-
buttons are attached to the assembly,
unsnap them from the old assembly,
and install them on the console at their
correct locations.
Top 3 Locking Tabs
Lower 4 Locking Tabs
Touchpad / LED Assembly
Touchpad / LED Assembly
FRONT VIEW
BACK VIEW
Touchpad / LED Assembly
Console Locking Tab
Pull Out
Console Screw