Filter
Top Products
2-2
1234562789675
Selecting the proper location for your washer improves
p
erformance and minimizes noise and possible washer “walk.”
Your washer can be installed under a custom counter, or in a
b
asement, laundry room, closet, or recessed area. See “Drain
S
ystem.”
C
ompanion appliance location requirements should also be
c
onsidered. Proper installation is your responsibility.
A water heater set to deliver 120 °F (49°C) water to the
washer.
A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See Electrical Requirements.
Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa).
A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 lbs (180 kg).
D
o not operate your washer in temperatures below 32 °F (0°C).
S
ome water can remain in the washer and can cause damage in
l
ow temperatures.
7544562783 4473
The location must be large enough to allow the washer door
to be fully opened.
Additional spacing should be considered for ease of
installation and servicing.
Additional clearances might be required for wall, door, and
floor moldings.
Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended to reduce noise transfer.
Companion appliance spacing should also be considered.
4867627
9 3278675445627843678283528
732 758675445627
The dimensions shown are for the recommended spacing.
93278675445627843678283828
325867544 5627865828652584854
The dimensions shown are for the recommended spacing.