Filter
Top Products
troubleshooting and information codes _33
Water detected over the safe
water level.
Call for service
Jammed Key. Call for service
Motor speed sensor problem. Restart the cycle.
If the code reappears, call for service.
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
Too much suds is detected during
the washing session.
The unit is put on hold until the
suds are reduced. Then, the unit
will resume operation.
When it finishes washing, the End
and Sd codes will blink in turn.
To prevent, reduce the amount of detergent.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
04 TROUBLESHOOTING
WF361_363_365-02832J-03_EN_20120829.indd Sec8:33WF361_363_365-02832J-03_EN_20120829.indd Sec8:33 2012-08-31 12:38:222012-08-31 12:38:22