Filter
Top Products
1DM 900 7sprachig
ENGLISH
■ For appliance description see diagram on page 3:
A Spray jet
B Water filling inlet with cover
C Variable steam control
D Spray button
E Shot of steam button
F Automatic switch-off indicator light
(depending on model)
G Temperature dial
H Flexible cord protector
I Mains supply cord
J Pilot light
K Extremely scratch-resistant
soleplate
L Transparent water tank
M Maximum water level indicator
SAFETY INSTRUCTIONS:
b The appliance complies with EU directives 72/23/EEC and 89/336/EEC.
̈ The appliance may only be connected to alternating current as specified
on the rating plate.
̈ If your home is fitted with a differential current switch, please ensure that
it is sensitive to pulse trains.
U.K. ONLY
SAFETY POINTS FOR REWIREABLE OR MOULDED PLUG:
̈ The mains lead is fitted with a BS 1363 13A plug.
̈ If the plug supplied with the product is not suitable for your socket outlet,
then it must be removed (cut off, if it is a moulded-on plug) and a suitable
3 pin plug fitted in accordance with the instructions given below.
IF YOU ARE IN ANY DOUBT, PLEASE CONTACT A QUALIFIED
ELECTRICIAN.
WARNING: Dispose of a plug that has been cut from the power supply cord,
as such a plug is hazardous if inserted in a live 13 amp socket outlet else-
where in the house.
How to connect the cord to a U.K. plug:
IMPORTANT!
The wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow Earth
Blue Neutral
Brown Live
Please read the instructions given below
before connecting the cord to a plug.
If you are in any doubt please consult a qualified
electrician.
As the colours of the wires in the mains lead
of this coffee maker may not correspond with
the coloured markings identifying the terminals
in your plug, proceed as follows:
̈ The wire that is coloured GREEN & YELLOW must be connected to the
terminal in the plug which is marked with the letter E, or the earth
Symbol , or coloured GREEN or GREEN & YELLOW.
̈ The wire that is coloured BROWN must be connected to the terminal
which is marked with the letter L or coloured RED.
̈ The wire that is coloured BLUE must be connected to the terminal which
is marked with the letter N or coloured BLACK.
̈ This appliance requires a 13 amp fuse.
̈ Should the fuse need to be replaced an ASTA marked fuse, approved to
BS 1362, of the same rating must be used.
̈ Always replace the fuse cover after fitting a fuse. The plug must NOT be
used if the cover is omitted or lost until a replacement is obtained - make
certain that only the correct fuse cover is used and fitted.
̈ For plugs with a detachable fuse cover, the replacement must be the same
as the colour insert in the base of the plug, or as directed by the em-
bossed working on the base of the plug.
̈ If the detachable fuse cover is lost, a replacement may be purchased from
a Rowenta Service Centre (see enclosed Service Information leaflet).
̈ Information for supply may also be obtained from the plug manufacturer.