Filter
Top Products
Extending the cooling down
time
The cooling down phase which takes
place before the end of a programme
can be lengthened if required. This
makes the garments easier to handle.
The cooling down time
–
can be extended by 5 minutes or 10
minutes.
–
can only be extended for
programmes with drying levels.
Follow steps A to F to programme
and store in memory.
The programmable functions are
activated with the buttons.
Before you begin, first ensure that:
– The tumble dryer is switched off.
– The door is closed.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Press the jk button in.
Wait until the indicator light for the Start/
Stop button lights up constantly
...
C . . . and then release the Start/Stop
button.
D Press the Low temperature button
four times.
–
The Low temperature indicator light
will briefly flash on and off seven
times.
– P and 0 (default setting) will flash
alternately in the display.
The number which appears alternately
in the display with P means:
0 Default setting
I The cooling down time will be five
minutes longer.
(The Automatic plus indicator light
will also flash once).
2 The cooling down time will be ten
minutes longer.
(The Automatic plus indicator light
will also flash twice).
E Pressing the Start/Stop button
switches from one number to
another.
F Switch the dryer off with the jk
button.
The setting you have selected is now
stored in memory. You can change it
again at any time.
Programmable functions
49