Filter
Top Products
F Start the programme
The Start/Stop button will flash when a
programme is being selected. The
flashing indicates that a programme
can be started.
^
Press the Start/Stop button.
The Start/Stop button will now light up
constantly.
* Drying will appear in the display and
the Perfect Dry indicator will flash.
The indicator will go out after approx. 1
minute and the estimated programme
duration will appear in the display.
Note: The duration shown in the display
is an estimate and can vary.
Before the end of a programme
* The Perfect Dry indicator will light up.
There is a cooling down phase at the
end of the drying sequence (Cooling
down will appear in the display). The
programme will not finish until the
cooling down phase has been
completed.
There is no cooling down phase at the
end of the Woollens handcare
programme.
* Only with programmes with drying
levels (exception: Gentle smoothing).
G Remove the laundry when the
programme has finished
0 and Finish will appear in the display
to indicate that the programme has
finished. The buzzer (if selected) will
sound at intervals.
The drum will continue to rotate at
intervals for up to two hours to prevent
laundry creasing, if you do not wish to
remove it immediately (anti-crease).
There is no anti-crease phase at the
end of the Woollens handcare
programme.
^ Press the Door button.
^ Open the door.
^ Remove the laundry.
Check that all items have been
removed from the drum. If items are
left in the dryer, they could be
damaged by overdrying when the
dryer is next used.
If the dryer is switched on at the mains
and the door is opened, the drum
lighting will come on. It will go out a few
minutes later to save energy.
^
Switch the dryer off by pressing the
jk button.
^
Clean the fluff filters.
^
Close the door.
^
Empty the condensed water
container (unless the dryer has been
connected for external drainage).
^
The condenser unit should be
checked and cleaned on a regular
basis (see "Cleaning and care").
How to dry correctly
14