Filter
Top Products
Levelling the tumble dryer
The appliance must be perfectly level
to ensure safe and proper operation.
^
The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
The air inlet and outlet vents on
the front of the tumble dryer must
not be covered as this would
prevent sufficient ventilation for
cooling the condenser unit.
,
Do not block the gap between
the bottom of the tumble dryer and
the floor with plinth facings, deep
pile carpet etc. This would hinder a
sufficient flow of air to the dryer.
Room in which the dryer is located
Air taken in for the drying process will
be warm when it is expelled from the
front of the dryer. This expelled air
heats up the air in the room. It is
therefore very important to ensure that
the room is adequately ventilated,
particularly if the dryer is located in a
small room. Otherwise drying durations
may be longer.
Washer-dryer stack
The tumble dryer can also be combined
with a Miele washing machine in a
washer-dryer stack. The appropriate
"WTV" stacking kit (available to order) to
match your dryer is required.
,
Stacking kits must only be
installed by a suitably qualified fitter.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run out
if the tumble dryer is tipped up when it is
being moved. It is a good idea to run the
Cool air programme for approximately 1
minute before moving the tumble dryer
.
Any remaining condensed water will then
be fed into the condensed water
container or out through the drain hose.
Installation
37