Filter
Top Products
With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages
Problem Possible cause Remedy
The programme
stops and
0 and Finish appear
in the display.
The buzzer sounds.
This is not a fault.
The electronic unit has
recognised that there is
no laundry or insufficient
laundry in the drum and
cancelled the
programme. Drying
individual garments or
items which are already
dry can also cause the
programme to be
cancelled.
Use the Warm air programme
for drying individual items.
– Open and shut the door.
0-§ appears in the
display.
The Low
temperature
indicator light is
flashing.
The electronic system
lock is activated.
You will need to deactivate the
system lock before the dryer
can be used (see "Electronic
system lock").
The programme
stops.
The buzzer sounds.
Cooling down or
Finish may also
flash in the display.
No obvious cause.
–
Switch the dryer off and back
on again.
–
Then start the programme
again.
If this problem happens again,
there is a fault. Contact Miele.
Bars are flashing at
the end of the
programme:
—œ–...C~–...Cœ˜...
The programme has
finished but the laundry
is still being cooled
down.
You can either unload the drum
and leave the laundry to cool at
room temperature or leave it in
the dryer to continue cooling.
Problem solving guide
28