Filter
Top Products
Fitting or changing the decor
panel
Note: The door should be shut for fit-
ting or changing the decor panel.
Remove the 4 screws from the decor
strip on the door catch side of the
door and remove the decor strip.
Unscrew the remaining 7 screws
from the lower and side decor strip
until the decor panel bows slightly
and can then be taken out or put in
place.
Reassemble in the reverse order and
tighten the screws.
Decor panel dimensions
The figures given in brackets indicate
the tolerance level in mm:
Width = 587 (-1) mm
Height = 602 (-1.5) mm
Thickness = 1 (+0.5) mm
Panels more than 1.5 mm thick require
an “adapter strip for a 4 mm thick
decor panel”. This is available from
your Miele Dealer or the Miele Spare
Parts Department.
Note: The decor panel height re-
quired for the adapter strip must not
exceed 596.5 (-1.5) mm.
Installation
34