Filter
Top Products
Installation
The machine must be perfectly level to
ensure safe and proper operation.
Minor differences do not, however,
have an adverse effect on operation.
The screw feet can be adjusted to
compensate for any uneveness in
the floor surface.
A ventilation gap of 10 mm must be
maintained between the bottom of the
machine and the floor. It must not be
blocked by deep pile carpets,
plinths etc, preventing a sufficient in-
take of cold air.
Building under a continuous work-
top/in a row of kitchen units
The space required by the vent duct
must be taken into consideration
when calculating the distance be-
tween the machine and a wall or
other appliances or furniture on
either side.
A special conversion kit* is necessary.
– The machine lid is replaced by a
coverplate which must be fitted by a
suitably competent person to ensure
electrical safety.
– Flat type ducting* is required if there
is not enough space for a vent duct.
– When installing under a worktop with
a working height of 900/910 mm, a
spacer kit* is necessary.
When built under, the running times
may be longer.
The dryer can be combined with a
Miele washing machine in a washer
and dryer stack. The appropriate stack-
ing kit* to match your washing machine
is required.
* These items are all available from your Miele
dealer.
(N.B. If you wish to push your machine
under a worktop and there is space to
do this without removing the lid, the
conversion kit is not necessary. Other-
wise the conversion kit is essential).
Installation
26