Filter
Top Products
What if the "Filter/Vent" fault indicator is lit?
Possible fault Solution
The lint filter is clogged. Clean the lint filters. See "Dryer care".
The air supply in the room is
insufficient.
Open a window or door to increase
airflow.
What if the program runs too long or stops?
Possible fault Solution
The airflow is insufficient in the area of
the dryer.
Open a window or door to increase
airflow.
The lint filters are clogged. Clean the lint filters (see "Dryer care").
The laundry was not spun sufficiently in
the washer.
Select a higher spin speed in the wash
program.
The dryer is overloaded. Reduce the load size.
Metal zippers interfere with the dryer’s
moisture sensors.
Select a timed program to avoid over
drying.
The condenser is clogged with lint or
detergent residue.
Clean the condenser periodically (see
"Dryer care").
The air vent below the door is blocked. Remove any blockages.
What if the laundry is not dry enough?
Possible fault
The load contained too many dissimilar items (size and fabric.)
What if water has collected around the drum opening?
Possible fault
This is condensed moisture from the laundry.
Frequently asked questions
21