Filter
Top Products
Check and indicator lights
What to do if . . . Cause . . . Remedy . . .
. . . the “Drying” indicator
light flashes.
The programme selector was
moved after the beginning of
the programme, but the
programme continues to run
correctly.
Turn the programme selector
back to its original position and
the light will go out.
. . . the “Anti-crease/Finish”
light flashes.
There could be a fault.
– Switch the machine off and
on again.
– Select the programme and
press “START”.
Cold surrounding temperatures
below freezing are affecting the
machine (frozen condensed
water).
– Install the appliance in a
warmer room.
If the light continues to flash there
is a problem. Contact Miele
Service Department.
. . . the “Empty out container”
light comes on.
The condensed water container
is full.
Empty the container.
Check that the condensed
water container is correctly
positioned.
. . . the “Clean out airways”
light comes on.
The fluff filters are blocked.
– Switch the dryer off with the
"l-On/0-Off" button.
– Clean the fluff filters after
every use. (See "Cleaning
and care").
The condenser unit may be
blocked because it has not
been cleaned for a long time.
– Switch the dryer off with the
"l-On/0-Off" button.
– Please note that the
condenser unit must be
cleaned regularly (see
"Cleaning and care").
. . . the programme is interrupted
and the “Anti-crease/Finish”
light comes on.
If there is no laundry in the drum when the programme is started,
the electronics will register this and stop the programme. The
programme will also be interrupted if the laundry placed in the drum
is already dry.
Problem solving guide
26