Filter
Top Products
Step 0 Select Control Dial Cycle INTELLIDRYWRINKLEFREEFABRICS WITH PRESS CARE
automatically senses the moisture in
the load and shuts off when the select-
_TELL_R_ ed dryness level is reached. It mini-
OFF MOREDRYREGULAR mizes wrinkles of synthetic fabrics
,LESSORV such as acrylic, nylon, polyester or
blends by providing a cool-down
period by tumbling the load in
unheated air at the end of the cycle.
6o Simply set the control to the desired
IN'TELI-IDRY dryness level (more dry - less dry).
WRINKLE FREE MOREDRY The line between more dry and less
FABRICS ;:-:: :'!
. _ /._;:: dry is the initial preferred setting for
the majority of loads.
DAMP DRY
DRYEL FABRIC CARE is designed for use on dry clean only fab- INTELLIDRY REGULAR automati-
rics in combination with Dryel, a dry clean only fabric care prod- cally senses the moisture in the load
uct. Placing the control dial arrow at START will provide the and shuts off when the selected dry-
ness level is reached. This cycle is
optimal amount of time needed to properly use Dryel. (For more
information on using the Dryel cycle, see page 7.) designed for loads such as towels,
underwear, t-shirts, jeans, etc. Set the
WRINKLE RELEASE will release wrinkles from items that are control to the desired dryness level
clean and dry but slightly wrinkled, such as from a crowded clos- (more dry - less dry). The line
et, packed suitcase or from sitting in the dryer too long after the between more dry and less dry is the
end of the cycle. It provides 10 minutes of heated tumbling and 5 initial preferred setting for the major-
minutes of cool down tumbling without heat. ity of loads.
DAMP DRY is designed to "partially" dry items. It provides
approximately 20 minutes of heated tumbling and 5 minutes of TIME DRY/AIR FLUFF may beselect-
cool down tumbling without heat. edfor any load if the lntelliDry sensor
system is not used. Set the control to
Step End of Cycle Signal the desired number of minutes and
choose the appropriate drying tern-
Shortly before the cycle is complete, an audible perature of the load. A time dry of up
signal will sound. If the Press Care option has to 60 minutes may also be selected.
been selected, the audible signal will sound _ HI Place the control dial pointer at the
intermittently during the cool down portion of desired number of minutes. Do not
Press Care. The signal can be turned off or vol- select the Dryel option button.
ume adjusted if desired.
Press Start Note: The dial can be turned in either
Step
direction to select a cycle. Once started,
the dial will not advance at a specific
Push this button to start the dryer. The dryer START rate during the IntelliDry cycles.At
door mustbe shut for the dryer to operate, If the first the dial may not advance at all.
door is opened during the cycle, the start button Towardthe end of the cycle (when the
load begins to dry) the dial willadvance
must be pushed again to resume the cycle once
at a more regular rate and much more
the door is closed, quickly. Thisis normal operation.
6