Maytag LAT8016 Washer User Manual


 
Care and Cleaning ...............................................
Turn off the water faucets after finishing the day's wash- Interior - hard water deposits may be removed, if
ing. This will shut off the water supply to the washer needed, using a recommended cleaner labeled wash-
and prevent the unlikely possibility of damage from er safe.
escaping water. Lint Filter - these are self-cleaning and require no
Use a soft cloth to wipe up all detergent, bleach or other maintenance. They are located under the agitator on
spills as they occur, the bottom of the washtub. During the wash and
rinse portion of
Clean the following as recommended:
the cycle, lint is
Control Panel - clean with a soft, damp cloth and glass collected on the
cleaner. Do not use abrasive powders or cleaning filters. Then dur-
pads. ing the spin and
drain the filters
Cabinet - clean with soap and water followed with an
are cleaned auto-
appliance wax, if desired.
matically.
Storing the Washer .............................................
Washers can be damaged if water is not removed from Advance the cycle control knob to Spin and lower the
hoses and internal components before storage. Prepare drain hose to eliminate any water that may be in the
the washer for storage as follows: drain hose.
Select the NORMAL cycle for regular fabrics and add Disconnect the washer from the electrical supply and
one cup of bleach or white vinegar to a full load of leave the washer lid open to let air circulate inside the
water without clothes. Run the washer through a tub.
complete cycle.
Turn the water faucets off and disconnect the inlet
hoses.
Water Use .............................................................
PERMANENT PRESS CYCLEREGULAR CYCLE