Filter
Top Products
20
2. Place drying rack inside dryer drum, positioning the back wire
on the ledge of the inner dryer back panel. Push down on
front feet of drying rack, at the same time, aligning the locator
tabs with the locator indentations in the dryer drum.
3. Put the wet items on top of the rack. Leave space between
the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the rack.
4. Close the door.
5. Select Dry Rack cycle. Items containing foam, rubber or
plastic must be dried on a clothesline or by using the Air Only
temperature setting.
6. You must select a time by pressing the MANUAL DRY TIME
(- or +) buttons. Reset time as needed to complete drying.
Refer to the following table.
7. Press and hold START button (about 1 second).
NOTE: You must remove rack for normal tumbling. Do not use
automatic cycles with the drying rack.
This chart shows examples of items that can be rack dried and
the suggested temperature setting and drying time. Actual drying
time will depend on the amount of moisture items hold.
*(Minutes) Reset time to complete drying, if needed.
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.
Cleaning the Lint Screen
Every load cleaning
The lint screen is located on the front of the dryer, below the door.
A reminder to CLEAN LINT SCREEN is displayed in the status
display window. A screen blocked by lint can increase drying
time.
To clean
1. Pull the lint screen straight out. Roll lint off the screen with
your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
NOTE: To completely remove the lint screen, depress the tab.
2. Push the lint screen firmly back into place.
IMPORTANT:
■ Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
■ If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. See “Venting
Requirements.”
As needed cleaning
Laundry detergent and fabric softener residue can build up on the
lint screen. This buildup can cause longer drying times for your
clothes, or cause the dryer to stop before your load is completely
dry. The screen is probably clogged if lint falls off the screen.
Clean the lint screen with a nylon brush every 6 months, or more
frequently, if it becomes clogged due to a residue buildup.
A.Dryer back panel
B. Locator tabs
C.Locator indentations (inside dryer drum)
Rack Dry Temp. Time*
Wool Sweaters
Block to shape and lay flat on the rack
Low 60
Stuffed toys or pillows
Cotton or polyester fiber filled
Low 60
Stuffed toys or pillows
Foam rubber filled
Air Only
(no heat)
90
Sneakers or canvas shoes Air Only
(no heat)
90
A
B
C
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.