Filter
Top Products
I I
5. Wash any dirt or other material from the debris filter. Make
sure the drain pump propeller behind the debris filter is not
blocked.
6. Replace the debris filter cap.
7. Replace the filter cover.
8. Close up the opening of drain tube with cap.
9. Don't insert the drain tube in the hole.
Replace inlet hoses after five years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage
your washer. If storing or moving your washer during freezing
weather, winterize it.
Non=use or vacation care:
Operate your washer only when you are at home. If you will be
on vacation or not using your washer for an extended period of
To use washer again:
1. Flush water pipes.
2. Reconnect water inlet hoses to faucets.
3. Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
4. Plug in washer or reconnect power.
5. Run the washer through the Normal/Casual cycle. Use only
HE High Efficiency detergent. Use 1Athe manufacturer's
recommended amount for a medium sized load.
To t_ansport the washer:
1.
2.
3.
If washer will be moved during freezing weather, put in 1 qt (1
L) of R.V.-type antifreeze in the drum. Run washer on a Drain
& Spin cycle.
Unplug the power cord.
Disconnect the drain hose from the drain system and attach
to rear panel clips.
4. Shut off both water faucets.
5.
6.
Disconnect the water inlet hoses from faucets, then drain the
hoses and clip them to the rear panel of the washer.
IMPORTANT: Call service. Reinsert the shipping bolts to
minimize internal washer damage that may occur during
transportation. Upon completion of moving, please do not
time, you should: forget to remove shipping bolts prior to installation, and keep
[] Unplug washer or disconnect power, them for future use. Unit must be transported in the upright
position. To avoid suspension and structural damage, your
[] Turn off the water supply to the washer. This helps avoid machine must be properly set up for relocation by a certified
accidental flooding (due to a water pressure surge) while you technician.
are away. .............................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
[] Slightly open door to provide ventilation.
To winterize washer:
Reinstalling the washer
1. Follow the "Installation Instructions" to locate, level and
connect the washer.
1. Put 1 qt (1 L) of R.V.-type antifreeze in the drum.
2. Run washer on a Drain & Spin cycle.
8. Unplug washer or disconnect power.
2,
Run the washer through the Normal/Casual cycle to clean
the washer and remove the antifreeze, if used. Use only
HE High Efficiency detergent. Use 1Athe manufacturer's
recommended amount for a medium sized load.
4. Shut off both water faucets.
5. Disconnect water inlet hoses from faucets and drain.
24
(Best 2)Keim_ore 592-49003-02902A-01 EN.i_dd 24
2011-03-23 /,_1i 9:39:58 I