2413UH, 2413SH Rev. 7/16/2012 12:27 PM / See Owner’s Manual for Warranty Information, Patented
© Copyright 2011, INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
HouseLinc GUI, PLM and free FilterLinc
HouseLinc
™
- INSTEON
®
Software with
Dual-Band Interface
Model: 2413UH, 2413SH
Introduction
HouseLinc is the ultimate INSTEON management software.
From simple setup through complex scene creation and
advanced automation, HouseLinc has you—and your entire
home—covered.
System Requirements
Windows 2000/XP/7/Vista (32/64 bit); 15MB disk space;
min. 128MB RAM; USB port (2413UH) or serial port (2413SH)
What's Included
• HouseLinc-enabled dual-band interface
• 6’ USB cable (2413UH) or 6’ DB9 serial cable (2413SH)
• FilterLinc powerline noise and attenuation filter
1) Shut down PC and related components that share a power strip (monitor, printer, fax, scanner, etc.)
2) Unplug power strip from wall and plug into the bottom outlet on FilterLinc
3) Plug FilterLinc directly into an unswitched wall outlet
4) Plug PLM into the pass-through outlet on the back of FilterLinc
5) Turn on PC
6) Open browser and go to www.smarthome.com/HL
7) Click DOWNLOAD button and follow onscreen instructions. (Note: do not launch HouseLinc yet.)
8) Connect cable to PLM and to PC
9) Launch HouseLinc
10) HouseLinc will automatically start looking for the PLM
11) Click on your PLM and click the Activate button
12) Select the Devices tab, click on the Add New Device Icon:
13) Press and hold Set buttons on your INSTEON devices
14) Create Scenes
15) Create Events
16) Have fun!
Owner’s Manual and Tech Support
Owner’s Manual and current Quick Start Guide: http://www.insteon.com/support
Call: INSTEON Support Line at 800-762-7845
This device complies with FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.
