Filter
Top Products
ENGLISH
12
WATER CONNECTION
IMPORTANT: Use the new water hoses supplied with the washer. Old hoses should
not be used.
1. Check that a flat washer is present and firmly in place in each end of the water
inlet hoses. Flat washers are pre-installed at the factory.
NOTE: Do not insert additional washers into the water hoses.
2. Connect the elbow coupling end of the water hoses to the inlet valves on the
washer. Then, connect the straight coupling end to the proper faucet.
NOTE: The washer's inlet valves have metric threads. The elbow coupling end of
the supplied water hoses have matching metric threads.
3. Connect the cold water faucet to the valve on the washer marked "C" and the hot
water faucet to the valve marked "H".
NOTE: Take care not to cross connect the hoses.
4. Check for hose connection leaks by fully opening the faucets. You may have to
use pliers to tighten connections.
NOTE: Do not over tighten hoses; this could cause damage to the washing
machine's valves.
C H
Pre-installed
Flat Washer