Filter
Top Products
FRONT LO-\D \\ tSIIER
PROCEDURE FOR REPL_kCING THE BOO I colmnued
141
1_)
17)
Replace the boot e\truslon back onto tile
duct and pull it up ovei tile ridge on the
duct neai the top of the opening
Reinstall the clamp m such a way that the
clamp sits between the ndges on the
extrusion and above the ndge on the duct
Snap the clamp closed _,,aththe copper
tubing tool that You used prexlously
Betbre attaching the new boot to the front
panel, clean the surface of the front panel
with alcohol or household cleaner Also
clean the fiat surface of the new' boot that ILLUSTRATION # 12
will be contacnng the front panel This
step _sneeded to remove the mold release matenal used in the manufactt,nng process and will allow
the adhesive to stick
ILLUSTRATION # 13
U'sing the adhesive supphed m the k_t,
spanngly apply dots of glue tinder the edge
ofthebootasshownm# 14
Spot glue at the 12 o'clock, 1, 2, 3, 4, 5 6,
7, 8 and 9 o'clock posmons around the
opening
161
Remount the boot onto the front panel as
shown in figure # l 3, making sure that
the boot is not wrinkled lflarge wrinkles
exist, the,,' may pool water m the boot and
dribble onto the floor v_hen the door is
opened
[fthis is the case, pull it loose from the front
panel and remount it slightly more clockwise
or counter clockwise as needed
ILLUSTRATION # 14
Caution the consumer to wait a couple of
hours before using the washer to allow the
adhesive enough time to dry
[ t'l)[ll I[