Electrolux EWW 148540 W Washer/Dryer User Manual


 
the procedure until water stops flowing
out;
6. clean the pump if necessary as previous-
ly described;
7. replace the emergency emptying hose
in its seat after having plugged it;
8. screw the pump again and close the
door.
Frost precautions
If the machine is installed in a place where
the temperature could drop below 0°C, pro-
ceed as follows:
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Place the end of the emergency empty-
ing hose and that of the inlet hose in a
bowl placed on the floor and let water
drain out.
4. Screw the water inlet hose back on and
reposition the emergency emptying
hose after having put the cap on again.
5. When you intend to start the machine
up again, make sure that the room tem-
perature is above 0°C.
WHAT TO DO IF…
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
During machine operation it is possible that
the red pilot light of button 8 blinks, one of
the following alarm codes appears on the
display and some acoustic signals sound ev-
ery 20 seconds to indicate that the machine
is not working:
: problem with the water supply.
: problem with the water draining.
: door open.
Once the problem has been eliminated,
press the button 8 to restart the pro-
gramme. If after all checks, the problem per-
sists, contact your local Service Centre.
Problem Possible cause/Solution
The washing machine does
not start:
The door has not been closed. E40
•Close the door firmly.
The plug is not properly inserted in the power socket.
Insert the plug into the power socket.
There is no power at the socket.
Please check your domestic electrical installation.
The main fuse has blown.
Replace the fuse.
The selector dial is not correctly positioned and the button 8 has
not been pressed.
Please turn the selector dial and press the button 8 again.
The delay start has been selected.
If the laundry are to be washed immediately, cancel the delay start.
The Child Safety Lock has been activated.
Deactivate the Child Safety Lock.
The machine does not fill:
The water tap is closed. E10
•Open the water tap.
The inlet hose is squashed or kinked. E10
Check the inlet hose connection.
The filter in the inlet hose is blocked. E10
Clean the water inlet hose filter.
The door is not properly closed. E40
•Close the door firmly.
The machine fills then emp-
ties immediately:
The end of the drain hose is too low.
Refer to relevant paragraph in «water drainage» section.
electrolux 23