Filter
Top Products
To switch off the end of program ‘beep’
The washing machine is factory set to ‘beep’ at the end of
your wash. It will also ‘beep’ when the machine has paused
after the Drip dry Deep rinse, to alert you to remove the drip
dry clothes from the washbowl.
To change the ‘beeping’ selection, proceed as follows:
1. Hold the Start/Pause button depressed for 3 seconds
2. Press the Temp. button to change the selection if
required.
in the digital display = ‘beep’ (ON)
in the digital display = ‘beep’ (OFF)
3. Press the Start/Pause button to store the selection.
7HENåNOå@BEEPåATåENDåOFåPROGRAMåISåSELECTEDåTHEåMACHINEå
will still ‘beep’ when buttons are pressed and for unavailable
selections.
tips and information
If you do not press Temp. or Start/Pause within 5 seconds
of the last button press or press any other button, the
machine will exit the programming mode. In this case the
setting will not have been changed and the machine will be
paused.
Soak option
This option allows you to soak heavily soiled clothes at the
beginning of the wash.
To do this, select the wash program you want to use, then
press the Soak button.
Pressing this button repeatedly gives you the soak
selections in the digital display,
eg. mins-- mins-- mins-- mins-- hour.
The lid must be closed to allow Soak functions to operate,
including the Intensive wash program 6 min. soak.
At various times during a soak, the recirculation pump
will turn on and off and the machine will agitate for short
periods. At other times, the clothes are soaking and the
machine will be doing nothing.
tips and information
During the soak period will be displayed and there will
be a short agitation at intervals to maximise the effect of the
detergent.
The wash will begin automatically at the end of the soak
period.
To cancel the soak period at any time, press the Soak
button repeatedly until is displayed.
Customising the auto sensing water level
If you are not happy with the water level when using auto
sensing water level selection, you can adjust the auto level
to be either higher or lower when you are in the program
setting mode.
7ITHåTHEåAUTOåSENSINGåLEVELåSELECTEDåHOLDINGåTHEå7ATERå
Level button depressed for 3 seconds will show the Auto
Adjust setting on the digital display:
optimised auto water level (factory set)
20mm higher than optimised water level
20mm lower than optimised water level
%ACHåPRESSåOFåTHEå7ATERå,EVELåBUTTONåAFTERåTHEålRSTåPRESSå
will change the Auto Adjust setting to the next water level
selection.
7HENåTHEåSETTINGåISåTHEåONEåYOUåWANTåASåSHOWNåINåTHEå
digital display, save it by pressing Start/Pause. The washer
will then be ready to start a wash program.
tips and information
)FåYOUåDOåNOTåPRESSå7ATERå,EVELåORå3TART0AUSEåWITHINåå
seconds of the last button press or press any other button,
the machine will exit the auto adjusting mode. In this case
the setting will not have been changed and the machine will
be paused.
Operating your washing machine
12 operating your machine electrolux water aid washing machine
Soak
button
Press and hold
for 3 seconds