Filter
Top Products
9
6. Start the programme
Before starting up the machine check that:
●
the appliance is plugged in
●
the water supply tap is turned on
●
the drain hose is correctly and securely positioned
●
the door and the detergent dispenser drawer are
closed.
To start the selected programme, press the “start
pause” button; the corresponding light stops flashing.
Only the “wash” light stays on.
The “door” light comes on to indicate that the door is
locked. The machine starts operating.
7. Altering an option or a
running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the “Start/Pause” button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to “O”
and then to the new programme position. The washing
water in the tub will not emptied out .
Start the new programme by depressing the
“start pause” button.
8. Interrupting a programme
Depress the “start pause” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart the
programme.
9.Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
10. Opening the door after the
programme has started
First set the machine to pause by pressing the “start
pause” button.
If the “door” light flashes and after 2 minutes goes off,
the door can be opened.
If the “door” light doesn’t flash, this means that the
machine is already heating, that the water level is above
the bottom edge of the door or that the drum is turning.
In this case the door can not be opened.
If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector
dial to “O”. After about 2 minutes the door can be
opened (pay attention to the water level and
temperature!).
1
1. At the end of the programme
The machine stops automatically.
If the “rinse hold” option has been selected, the phase
lights “end” and “door” illuminate, the “start pause”
light goes off and the door remains locked to indicate
that the water must be emptied out before opening the
door.
To do this first turn the programme selector dial to “O”
and then to “drain programme”
14
or “spin programme”
15
. Reduce the spin speed if needed, by means of the
relevant button.
Release of the lock is also indicated by the coming on of
the “end” light.
Turn the programme selector dial to “O” to switch the
machine off.
Remove the laundry from the drum and carefully check
that the drum is empty.
If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
132986851.qxd 16/01/2006 08:53 Pagina 9