Filter
Top Products
28
Avaya Definity Gx/PBXLink Integration Guide for Cisco Unity 3.1
OL-1846-06
Dual Phone System Integration
Changing Cisco Unity Administrator Settings
The access code is the same number that subscribers on the circuit-switched phone system dial to reach
someone on the Cisco CallManager system.
Step 3 Adjust other settings as applicable. For more information about the other settings on the Switch page,
refer to the Cisco Unity Administrator Help.
Step 4 Click the Save icon, then click OK in the Warning dialog box.
To specify switch settings for Cisco CallManager
Step 1 Go to System > Switch > IP Switch.
Step 2 In the Set Active Switch Type section, enter values as shown in the following table:
Step 3 Click Set As Active, then click OK in the Warning dialog box.
Step 4 In the Access Code field, enter the trunk access code that Cisco Unity must dial to transfer calls to the
circuit-switched phone system from Cisco CallManager.
The access code is the same number that subscribers on Cisco CallManager dial to reach someone on the
circuit-switched phone system.
Step 5 Click the Save icon, then click OK in the Warning dialog box.
To Modify Voice Port Settings
Step 1 In the Cisco Unity Administrator, go to the System > Ports page.
Step 2 In the Port Assignments section, indicate the range of ports to be assigned to the circuit-switched phone
system. The port range for the circuit-switched phone system begins with 1 and extends to no more than
the number of ports that are on the installed voice cards. Do not assign more ports to the circuit-switched
phone system than the number of ports on the voice cards.
Caution If you assign fewer voice ports to the circuit-switched phone system than are available on the
installed voice cards, you must edit the registry for this port range to take effect. Otherwise,
all available voice ports on the voice cards are used in the integration regardless of the Port
Assignments settings. For information on editing the registry for the port range, see the
appendix “Assigning Dialogic Ports for a Dual Phone System Integration.”
Step 3 In the Port Assignments section, indicate the range of ports to be assigned to Cisco CallManager. The
port range must begin with the next port after the last port for the circuit-switched phone system. The
range for Cisco CallManager must end with the port number of the last port displayed on the Ports page,
Table 23 Switch Settings
Switch Parameter Required Setting
Manufacturer Cisco
Model CallManager
Switch PBX software version 3.01 or later
Integration TAPI