Filter
Top Products
28 EN
No water can
be seen in the
machine during
washing.
This is not a problem. The
water level is not visible
from the outside of the
machine.
The door is
jammed.
Water level might be above
the lower level of the door.
Runeitherthe“Pump”or“Spin”program.
Machinemightbeheating
up the water or it may be at
the spinning cycle.
Wait until the process is over.
Due to electrical safety
mechanism, the door can
only be opened a few
minutes after the program
has stopped.
Wait until the process is over.
Machinefills
with water
when a process
is cancelled.
Inside of machine may be
hot.
For safety reasons, water should be cycled in and
out a couple times.
Washing time
takes longer
than the time
specified in the
manual
Water pressure may be
low.
The machine will wait until there is a sufficient
amount of water, which may lengthen the
washing time to avoid poor washing results due to
insufficient water.
Supply voltage may be low.
Washing time is lengthened to avoid poor washing
results when the supply voltage is low.
Input temperature of water
may be low.
Cycle time lengthens to heat up the water when
the input water is cold. Also, washing time can be
lengthened to avoid poor washing results.
There may be an imbalance
of laundry in the machine.
The automatic spin correction system might have
been activated due to the unbalanced distribution
of the laundry in the drum.
Thelaundryinthedrummaybeclustered(bundled
laundryinabag).Laundryshouldberearranged
and re-spun.
No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
Number of rinses and/or
amount of rinse water might
have increased.
Water amount is increased to obtain a better rinse
and a rinse cycle is added when necessary.