Filter
Top Products
13
a. Reassembly Instructions For Non-Tilt Steam Dryers:
Lift the basket (tumbler) section onto the base.
1) The dryer has four (4) support posts assemblies which are located in each corner of the base. On
top of each post assembly is a clevis block which must be bolted to the basket (tumbler) section.
Use the 4-1/2” diameter x 1-1/8” long bolts and lock washers to bolt each clevis block to the basket
(tumbler) section. (Refer to View 1 on the previous page.)
2) Basket (tumbler) power cable reconnection:
a) A plug and cable is located in the right of the base. This must be lifted up and reconnected into
the mating socket located at the bottom of the right basket (tumbler) section.
b) Pull the basket (tumbler) section power cable up from the left side of the base through the hole
in the bottom of the basket (tumbler) section. Reconnect the wires of this cable into the 2-inch
x 4-inch (5.08 cm x 10.16 cm) basket (tumbler) junction box located at the bottom of the basket
(tumbler) section. (Refer to the illustration on the previous page.)
c) Drop the control cable connector from the rear right side of the basket (tumbler) section into the
base. Reconnect the industrial grade plug in to its mating socket.
3) Bolt the 24-inch (60.96 cm) diameter exhaust duct transition piece to the dryers rectangular exhaust
duct. The exhaust duct exits the dryer from the rear of the base. (Refer to the illustration on the
previous page.) Use the 1/4-20 self drilling screws supplied with the dryer.
4) If a steam dryer is shipped in two (2) pieces, the steam coil may have been removed from the top of
the basket (tumbler) section and shipped with the base. If this is the case, lift the steam coil on to the
top of the basket (tumbler) section with the steam pipe connections facing towards the right side of
the dryer and bolt the coil to the top of the dryer with a 1/4-inch hardware supplied. There are three
(3) panels that cover the front, right side, and rear of the steam coil. Fasten these in position also.