Filter
Top Products
63
P. Dryer stops during a cycle, microprocessor controller (computer) buzzer (tone) sounds for a
few seconds, and then microprocessor controller (computer) L.E.D. (light emitting diode)
returns to FILL...
1. Loose connection somewhere in the main power circuit to the microprocessor controller (computer).
Q. Microprocessor controller (computer) L.E.D. (light emitting diode) display reads SEFL...
1. Rotational sensor circuit failure... fault somewhere in the tumbler (basket) rotation or circuit ...
a. Tumbler (basket) not rotating ...
1) Broken tumbler (basket) drive belt.
2) Failure in drive motor circuit.
b. Bad rotation sensor.
c. Broken wire or connection between rotation sensor and microprocessor controller (computer).
d. Magnet missing or gap to large.
R. Microprocessor controller (computer) L.E.D. (light emitting diode) reads Hot...
1. Possible overheating condition... microprocessor controller (computer) has sensed a temperature
which has exceeded 220° F.
Hot display will not clear until temperature sensed has dropped to 220° F or lower and the
microprocessor controller (computer) is manually reset by pressing the CLEAR/STOP key.
S. No heat (for STEAM MODELS ONLY)... both microprocessor controller (computer) L.E.D.
(light emitting diode) heat indicator dot and the HEAT relay output L.E.D. are on...
1. Fault in 225° hi-heat (limit) switch circuit or thermostat.
2. No (external) compressed air to steam damper... 80 PSI required.
3. Failed steam damper 24 VAC pneumatic solenoid valve.
4. Failed steam damper pistons.
5. Steam damper stuck closed.
T. Dryer operates but is taking too long to dry...
1. Exhaust duct work run is too long or is undersized... back pressure cannot exceed .3 inches water
column (W.C.).
2. Restriction in duct work... check duct from the dryer all the way to the outdoors.
3. Low and/or inconsistent gas pressure (for GAS MODELS ONLY).