Filter
Top Products
53
e. Right Load Door Glass (Window) Replacement
1) Remove ALL of the old silicone from around
the door glass.
2) Clean glass door opening (with alcohol) to
remove ALL of the old silicone.
3) Carefully clean new door glass with alcohol prior
to installation.
4) Apply a bead of silicone (ADC Part No. 170730)
to the outer perimeter of the door glass opening.
Carefully insert new door glass within door
glass opening.
5) Allow a full 72 hours for the silicone to cure.
6) Trim excess silicone (with razor blade) after cure
time.
d. Proximity Switch Replacement
1) Discontinue electric service to the dryer.
2) Remove the two (2) 1/4-20 x 1/2" bolts from
each side of the middle guard and rear guard.
3) Remove the three (3) 1/4-20 x 3/4" bolts from
the bottom guard.
Remove the bottom guard.
4) Remove the two (2) 8-32 x 3/4" screws on each
door that connect/attach the cable cylinder to
the door.
5) Remove the two (2) 1/4-20 x 1-1/4" hex head
machine screws ...
a) Take notice to the wheel assembly
configuration.
6) Lift the door(s) off of the track and remove.
7) To install new pneumatic automatic door(s) or
to reinstall pneumatic automatic door(s), reverse
above procedure (step #6 through #1).