American Dryer Corp. AD-200 Clothes Dryer User Manual


 
42
2. Component Replacement
a) Blower (impellor and fan) Motor Replacement
1) Discontinue electric service to the dryer.
2) Mark and identify the wires that will be removed for proper reinstallation.
3) Loosen the bolts from the motor to the motor base ...
(a) Slide the blower (fan and impellor) motor forward.
(b) Remove the V-belts.
(c) Remove loosened bolts.
4) Remove the bolts from the bushing.
5) Insert bolts into the threaded holes.
6) Tighten the bolts evenly for motor pulley removal.
MAN3286
7) Mark the inside of the motors' shaft before removing the
bushing.
8) Loosen the set screws on the bushing.
9) Remove the bushing.
10) Measure the mark on the shaft (from Step #7) to the end of the shaft and mark the new motors'
shaft.
11) Slide the motor pulley on to the new blower (fan/impellor) motors' shaft.
12) Slide the bushing on to the shaft until the inside of the bushing meets the mark (from Step #11)
on the new motors' shaft.
13) Tighten the set screws on the bushing.
14) Insert bolts into the large holes on the bushing and thread
them into the motor pulley.
15) Tighten the bolts evenly for motor pulley installation.
16) Aline the pulleys.
17) Tighten (hand tight only) the bolts from the new motor to
the motor base ...
Leave enough movement for V-belt adjustment.
MAN3286