Filter
Top Products
21
F. ELECTRICAL INFORMATION
1. Electrical Requirements
It is your responsibility to have ALL electrical connections made by a properly licensed and competent
electrician to assure that the electrical installation is adequate and conforms with local and state
regulations or codes. In the absence of such codes,
ALL electrical connections, material, and
workmanship must conform to the applicable requirements of the National Electrical Code ANSI/NFPA
NO.70-LATEST EDITION.
IMPORTANT: Failure to comply with these codes or ordinances, and/or the requirements
stipulated in this manual can result in personal injury or component failure.
NOTE: Component failure due to improper installation will VOID THE WARRANTY.
Each dryer should be connected to an independently protected branch circuit. The dryer must be con-
nected with copper wire ONLY. DO NOT use aluminum wire which could cause a fire hazard. The
copper conductor wire/cable must be of proper ampacity and insulation in accordance with electric codes
for making ALL service connections.
NOTE: The use of aluminum wire will VOID THE WARRANTY.