Filter
Top Products
22 American Dryer Corp. 113243-1
PROCEDURE FOR
FUNCTIONAL CHECK OF
REPLACEMENT
COMPONENTS
Microprocessor Controller (Computer) Board
Phase 7 Coin Models
Upon completing installation of the replacement
microprocessor controller (computer) board,
reestablish power to the dryer.
Start the drying cycle by pressing any temperature
selection keys (HI, MED, or LO).
Verify that the applicable indicator lights on the
microprocessor controller (computer) board are
lit. (Refer to the illustration below.)
Phase 7 Non-Coin Models
Upon completing installation of the replacement
microprocessor controller (computer) board,
reestablish power to the dryer.
Start the drying cycle by pressing any of the preset
cycles in letters A-F.
Verify that the applicable indicator lights on the
microprocessor controller (computer) board are
lit. (Refer to the illustration below.)