Filter
Top Products
113243-1 www.amdry.com 21
THE DATA LABEL
MODEL NUMBER
The model number is an ADC number, which
describes the size of the dryer and the type of
heat (gas, electric, or steam).
SERIAL NUMBER
The serial number allows ADC to gather
information on your particular dryer.
MANUFACTURING CODE NUMBER
The manufacturing code number is a number
issued by ADC, which describes ALL possible
options on your particular model.
TYPE OF HEAT
This describes the type of heat for your particular
dryer: gas (either natural gas or liquid propane
[L.P.] gas), electric, or steam.
HEAT INPUT (FOR GAS DRYERS)
This describes the heat input in British Thermal
Units per Hour (Btu/hr).
ORIFICE SIZE (FOR GAS DRYERS)
Gives the number drill size used.
ELECTRIC SERVICE
This describes the electric service for your
particular model.
GAS MANIFOLD PRESSURE (FOR GAS DRYERS)
This describes the manifold pressure taken at
the gas valve tap.
DATA LABEL INFORMATION
When contacting American Dryer Corporation, certain
information is required to ensure proper service/parts
information from ADC. This information is on the data label
that is affixed to the upper left side panel area behind the top
control (access) door. When contacting ADC, please have
the
model number and serial number available.
ADJUSTMENTS
7 DAYS AFTER INSTALLATION AND EVERY 6 MONTHS
THEREAFTER
Inspect bolts, nuts, screws, setscrews, grounding
connections, and nonpermanent gas connections (unions,
shutoff valves, and orifices). Motor and drive belts should be
examined. Cracked or seriously frayed belts should be
replaced. Tighten loose V-belts when necessary. Complete
operational check of controls and valves. Complete
operational check of
ALL safety devices (door switches, lint
drawer switch, sail switch, burner, and hi-limit thermostats).
LUBRICATION
The motor bearings, idler bearings and under normal/most
conditions the basket (tumbler) bearings are permanently
lubricated. It is physically possible to relubricate the basket
(tumbler) bearings if you choose to do so even though this
practice
is not necessary. Use Shell Alvania #2 grease or its
equivalent. The basket (tumbler) bearings used in the dryer
DO NOT have a grease fitting. Provisions are made in the
bearing housing for the addition of a grease fitting which can
be obtained elsewhere, or from ADC by ordering kit P/N
882159 (includes two [2] fittings).