Filter
Top Products
23
2. Electrical Service Specifications
* AWG Stranded Type Wire ... size wire as per National Electrical Code or local codes.
(Motor lead type wire is recommended).
IMPORTANT: The dryer must be connected to the electric supply shown on the data label that is
affixed to the left side panel/wall area behind the control door. In the case of 208
VAC or 240 VAC, the supply voltage must match the electric service specifications of
the data label exactly.
WARNING: 208 VAC AND 240 VAC ARE NOT THE SAME. Any damage done to dryer
components due to improper voltage connections will automatically VOID THE
WARRANTY.
NOTE: ADC reserves the right to make changes in specifications at any time without notice or
obligation.
ADG-120ES II Reversing, 3ø (GAS)
ADS-120ES II Reversing, 3ø (STEAM)
ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER)
IMPORTANT: 208 VAC AND 240 VAC ARE NOT THE SAME. When ordering, specify exact voltage.
NOTES: A. When fuses are used they must be dual element, time delay, current limiting, class RK1 or RK5 ONLY.
Calculate/determine correct fuse valve, by applying either local and/or National Electrical Codes to listed
appliance amp draw data.
B. Circuit breakers are thermal-magnetic (industrial) motor curve type ONLY. For others, calculate/verify correct
breaker size according to appliance amp draw rating and type of breaker used.
C. Circuit breakers for 3-phase (3ø) dryers must be 3-pole type.
SERVICE
VOLTAGE
PHASE
WIRE
SERVICE
APPROX.
AMP DRAW
MINIMUM
WIRE SIZE
FUSING
CIRCUIT
BREAKER
Dual Element
Time Delay
60 Hz 50 Hz 60 Hz 50 Hz 60 Hz 50 Hz
208 3ø 3/4 11.8 --- * 20 --- 20 ---
240 3ø 3 13.0 16.7 * 20 25 20 25
380-400 3ø 3/4 --- 8.0 * 15 --- 15 ---
416 3ø 3/4 --- 8.4 * 15 --- 15 ---
460/480 3ø 3/4 7.0 --- * 15 --- 15 ---
575 3ø 3 5.8 --- * 15 --- 15 ---