Filter
Top Products
49
H. Both drive motor and blower motor run a few minutes and then stop...microprocessor controller
(computer) display continues to read time or percent of extraction and all indicator dots are off...
1. Fault in main door switch circuit ...
a. Failed main door switch.
b. Main door switch out of adjustment.
c. Loose connection in door switch circuit.
2. Fault in lint drawer switch circuit...
a. Lint drawer switch out of proper adjustment.
b. Loose connection in the lint drawer switch circuit.
I. Microprocessor (computer) display reads "dSFL"...
1. Fault in microprocessor heat sensing circuit ...
a. Blown 1/8-amp ("dSFL") fuse on microprocessor controller (computer).
b. Failed microprocessor temperature sensor.
c. Failed microprocessor controller (computer).
d. Broken wire or connection somewhere between the microprocessor controller (computer) and the micro-
processor temperature sensor.
J. Microprocessor controller (computer) display reads "door"...
1. Fault (open circuit) in main door or lint drawer switch circuit ...
a. Lint drawer is not closed all the way.
b. Lint drawer switch out of proper adjustment.
c. Failed lint drawer switch.
d. Failed main door switch.
e. Broken connection or wire in main door or lint drawer circuit.
f. Failed 24 VAC Transformer.
K. Microprocessor controller (computer) will not accept any keyboard entries, i.e., L.E.D. display
reads "FILL" and when keyboard entries are selected, the L.E.D. display continues to read
"FILL"...
1. Failed keyboard label (touchpad) assembly.
2. Failed microprocessor controller (computer).