Filter
Top Products
Operating Instructions
31
Power failure dur-
ing a wash pro-
gramme (all
indicator lights
are off).
The failure may be caused by
a blown house fuse or by a
mains supply fault into the
house.
(For safety reasons, the door
remains locked for around
2minutes.)
The programme continues
when power is restored.
If washing has to be taken out
during a power cut:
Turn the control knob to
I (OFF).
Carry out emergency emptying
(see Section "Carry out emer-
gency emptying“).
After about 2 minutes,
the door can be opened by
pulling on the handle.
Remnants of deter-
gent are building
up in the detergent
drawer.
The water tap is not fully
opened.
Open the water tap fully.
The inlet hose filter in the in
coupling of the inlet hose at
the tap is blocked.
Close the water tap. Unscrew
the inlet hose from the water
tap and from the machine.
Clean the filter.
The rinse water is
cloudy.
The cause is probably a deter-
gent with a high silicate con-
tent.
This has no negative effects on
rinse results; use a liquid de-
tergent if necessary.
When pressing
a programme op-
tion button,
the corresponding
indicator does not
light up.
The selected programme op-
tion cannot be combined with
the set programme.
Make another selection.
Problem Possible cause Remedy