Member Discussion
on General Electric WCSR2070T Washer
Load Size Wiring
I recently had a repair on my washer that required the Load Size control and assembly to be removed to remount the timer to the assembly plate (broken tabs). When replaced, what could have caused an overflow of water (regardless of load size selection)? This was not a pre-existing condition nor continued after the repairman returned and adjusted the wiring on this control. I know there are what appears to two ground type wires and a black connection to the control. I'm desperate for answers and can't seem to get a response from anyone I have called/written with a most likely or probable cause in their expertise to what may have occurred in the repair/reassembly that caused the overflow. Any assistance would be greatly appreciated. Thank you!
Six Ways to Fight Static Cling
Cloth Diapers vs. Disposables: Which Is Right for You?
Member Tips about LAUNDRY
